milesvdustin
Well-Known Member
I am planning out my pump system for my all grain brewing rig. Well, rig is a loose term. Its coolers on a table. But I want to be able to pump from my kettle to the MLT cooler to fill it with water, and the same with the HLT cooler. Would I be best served by just drilling through the lid and adding a fill port that way in each cooler? Or through the side? I am going to be outfiting the kettle, cooler valves, pump, and chiller with camlock fittings. The only part I can't think of a good idea for is filling the coolers.
Eventually this will be a one-pump electric kettle system, with coolers for the MLT and HLT so I can make an easy control panel and keep costs low.
Eventually this will be a one-pump electric kettle system, with coolers for the MLT and HLT so I can make an easy control panel and keep costs low.