mpenn35
Well-Known Member
So I've got a Danby kegerator and it's got a North American Dispensing Systems model 70012 regulator on it. I can't seem to find any information on this regulator. Two questions:
There is a valve on the bottom of the regulator on the hose that goes into the keg. Which was is open? I'm getting changes in pressure with it each way, and now I'm not sure if having it up and down/parallel to the hose is open or if parallel to the ground/sideways is open. I know it's a dumb question but I'm new to kegging and I don't know how much I can be turning the gas on and off figuring this out.
Second, the needles on my regulator seem to be fixed in one location. They were working fine, and I was tightening my regulator because I could hear a small leak and then I checked them and they're both stuck, with the one to adjust pressure sitting at 13 psi. I was able to adjust the screw fine to raise and lower the pressure and the gauge worked, now it doesn't.
Any help?
There is a valve on the bottom of the regulator on the hose that goes into the keg. Which was is open? I'm getting changes in pressure with it each way, and now I'm not sure if having it up and down/parallel to the hose is open or if parallel to the ground/sideways is open. I know it's a dumb question but I'm new to kegging and I don't know how much I can be turning the gas on and off figuring this out.
Second, the needles on my regulator seem to be fixed in one location. They were working fine, and I was tightening my regulator because I could hear a small leak and then I checked them and they're both stuck, with the one to adjust pressure sitting at 13 psi. I was able to adjust the screw fine to raise and lower the pressure and the gauge worked, now it doesn't.
Any help?