Hi All,
I had been pretty happy with my Barley Crusher as my first mill. However, it recently stopped causing grain. Upon inspection, I noticed the roller attached to the crank/drill was no longer attached to the opposite side (see highlight in photo), causing a wide gap. I had not looked at it that closely to see how the roller was attached, but I couldn't find that any piece had fallen off. Maybe the axel the roller is mounted on slid towards the drill side?
Support seems to be sketchy. Any thoughts on how to get this repaired myself or should I just start looking for a new mill?
I had been pretty happy with my Barley Crusher as my first mill. However, it recently stopped causing grain. Upon inspection, I noticed the roller attached to the crank/drill was no longer attached to the opposite side (see highlight in photo), causing a wide gap. I had not looked at it that closely to see how the roller was attached, but I couldn't find that any piece had fallen off. Maybe the axel the roller is mounted on slid towards the drill side?
Support seems to be sketchy. Any thoughts on how to get this repaired myself or should I just start looking for a new mill?