I couldn't find this on another thread, so I apologize if it duplicates another thread.
I used my Barley Crusher for the first time today. After crushing my grain, I discovered an O-Ring had walked halfway across the active roller. I can't tell which side it came from, as neither side seems to have an o-ring.
Also, the drill I used is a corded, single speed drill. Is it better to crush at full speed, or going about half-speed?
I used my Barley Crusher for the first time today. After crushing my grain, I discovered an O-Ring had walked halfway across the active roller. I can't tell which side it came from, as neither side seems to have an o-ring.
Also, the drill I used is a corded, single speed drill. Is it better to crush at full speed, or going about half-speed?