so i have my brutus to the point where i can test out the burners. i mounted all 3 spots with banjo burners 2 from a kab5 and 1 from a kab4 (didnt plan it that way it was just what i got) i mounted from the tip of the jets to the keggle mounting surface 2.25in. i am running a 5-35psi ajustable regulator and currently playing with an adjustable needle valve to adjust the propane flow. so after playing with the regulator valve and carb on the burner i can get a blue cone to sit about 3/4 of an inch out of the jets. so when bringing my keggle with about 12 gal in it from 60 deg F to 212 deg F I ran the carb wide open and the regulator/ needle valve combo with just enough gas to keep the flame from coming through the corners and up the side of the keggle.
now my question is should i raise the burner to get the blue cones up so they touch the keggle? drop it down and run the burner harder? or run the burner harder where it is and not care about the flame coming up the side of the keg.
any help is greatly appreciated, thank you for the help.
now my question is should i raise the burner to get the blue cones up so they touch the keggle? drop it down and run the burner harder? or run the burner harder where it is and not care about the flame coming up the side of the keg.
any help is greatly appreciated, thank you for the help.