WhiteEagle1
Well-Known Member
Hey guys,
I have a standard fridge, freezer on top, that I am making into a fermenting chamber. For heat I am mounting an infrared reptile bulb inside the fridge. My ebay temp controller will be in a project box mounted on the outside of the top of the unit.
My question is, what is the best way to run the power wires to the bulb inside the fridge as well as well as the temp reading wire? I thought about just running the wires over the door frame and putting some duct tape over them.....but worried the fridge door won't seal correctly? Is there a spot anyone has found you can drill a small hole without damaging anything? Or any other ideas?
Thanks!
I have a standard fridge, freezer on top, that I am making into a fermenting chamber. For heat I am mounting an infrared reptile bulb inside the fridge. My ebay temp controller will be in a project box mounted on the outside of the top of the unit.
My question is, what is the best way to run the power wires to the bulb inside the fridge as well as well as the temp reading wire? I thought about just running the wires over the door frame and putting some duct tape over them.....but worried the fridge door won't seal correctly? Is there a spot anyone has found you can drill a small hole without damaging anything? Or any other ideas?
Thanks!