jrodder
Well-Known Member
So I am battling a new brew, I might have let it get away from me, just need some advice. Brewed a dunkel with WLP380. I didn't read the yeast profile very clear, I was hoping to get some banana flavors, but it looks like that one was more clove oriented. I usually ferment in a swamp cooler, but this one I wanted to be higher to get more esters. SO... 24 hours later, temp was at about 72, reading from outside strip. We turn off the heater at night, and house gets down to 55-60 or so. I wrapped it in a blanket figuring it should stay about steady, maybe rise a tick. Woke up and it was at 80. Uncovered from the blanket, house heat back on. Then it was about 72 or so. That night, I was afraid to cover it again, so let it sit out. That morning, woke up to it at 66 degrees, and slow airlock.
Been covered back up today, with house heat on and its still reading about 66-68. I figure at this point whatever off flavors are there, so I should shoot to just stabilize it and make sure the yeast don't freak out anymore and at least finish the job.
Am I going to end up with a bubblegum off-flavored nightmare? Normally I use a very large vessel of water with the swamp method, and keeps the temp steady around 68 day and night.
Thoughts?
Been covered back up today, with house heat on and its still reading about 66-68. I figure at this point whatever off flavors are there, so I should shoot to just stabilize it and make sure the yeast don't freak out anymore and at least finish the job.
Am I going to end up with a bubblegum off-flavored nightmare? Normally I use a very large vessel of water with the swamp method, and keeps the temp steady around 68 day and night.
Thoughts?