I picked up a 56 qt Coleman from BJs. The drain comes out easily. It sits in a channel inside the cooler. I got some metric fender washers that are almost exactly 5/8" (just over, in fact) - they barely fit onto the Watts A-786 brass pipe nipple... the problem is that the washer is too big to fit snugly inside the channel. There's no way I can get a seal against the cooler's inside ring.
Has anyone else used this cooler? Any solutions?
Is there a 5/8 fender with a smaller outside ring? The outside diameter is about 2" and it's the only thing in full stainless I've found (Ace hardware).
Has anyone else used this cooler? Any solutions?
Is there a 5/8 fender with a smaller outside ring? The outside diameter is about 2" and it's the only thing in full stainless I've found (Ace hardware).