NoNothing
Well-Known Member
Finished build, 3 running.
All the parts I need. I went with a pretty dang fast (2300RPM) 120mm fan. Speed controller is off Amazon and the rest is 3D printed or screws
Getting everything all wired up and into the shell
Bought 5/8"x1/4" magnets off McMaster for I think $8 per. They're over kill, I could have gone with something weaker. These will pull the stir bar in from anywhere. I glue them to the shell I designed to fit on the fan so they're centered.
There we go, glued on the fan and perfectly centered.
#6 screws and some washers for adjustable spacing.
Wire the fan up and trim the screws