C cshelden Active Member Joined Feb 5, 2012 Messages 43 Reaction score 0 Location OKC Feb 21, 2016 #1 Buddy has a brew pot that was used in an electric setup. He is going to use gas. Anyone know if a source for 1" npsm plug to fill this hole?
Buddy has a brew pot that was used in an electric setup. He is going to use gas. Anyone know if a source for 1" npsm plug to fill this hole?
S sandyeggoxj Well-Known Member Joined Jan 15, 2011 Messages 3,196 Reaction score 540 Location Sunshine and Big Holes Feb 21, 2016 #2 Have you tried a regular 1" plug? Otherwise I would try mcmastercarr
OP OP C cshelden Active Member Joined Feb 5, 2012 Messages 43 Reaction score 0 Location OKC Feb 21, 2016 #3 No I've not. Not sure if nps is compatible with npt.
S sandyeggoxj Well-Known Member Joined Jan 15, 2011 Messages 3,196 Reaction score 540 Location Sunshine and Big Holes Feb 21, 2016 #4 Nps is straight and npt is tapered. Same thread otherwise.
OP OP C cshelden Active Member Joined Feb 5, 2012 Messages 43 Reaction score 0 Location OKC Feb 21, 2016 #5 Thanks, I knew NPS was straight and other taper didn't know pitch etc was same. I'll let him know, with some teflon it will seal nice I bet.
Thanks, I knew NPS was straight and other taper didn't know pitch etc was same. I'll let him know, with some teflon it will seal nice I bet.
