brian_n
Well-Known Member
I'm building my first kegerator, and I bought some seemingly standard size parts: a 1/4" barbed tail piece for the shank and 3/16" Bev-Seal tubing. When they arrived at my house, I realized that I'm an idiot and they don't fit together because of the size difference. Has anybody else had this same problem? If so, how did you resolve it? I've read that 3/16" tubing is best for reducing foam out of the faucet, but I can't seem to find a 3/16" barb anywhere.
I've read on here that some people take the gas tubing and put the end in boiling water for 30 seconds or so, and then stretch it over the barb. Has anybody done this with the liquid tubing? The Bev-Seal tubing says to not exceed 150F....
Thanks
I've read on here that some people take the gas tubing and put the end in boiling water for 30 seconds or so, and then stretch it over the barb. Has anybody done this with the liquid tubing? The Bev-Seal tubing says to not exceed 150F....
Thanks