Two Wire RTD PT100 question - Page 2 - Home Brew Forums
Register Now For Free!

Home Brew Forums > Home Brewing Beer > Automated Brewing Forum > Two Wire RTD PT100 question

Thread Tools
Old 05-10-2013, 03:47 AM   #11
Rbeckett's Avatar
Dec 2011
Bronson, Fl
Posts: 995
Liked 70 Times on 49 Posts

The My Pins are set up to switch an SSR. So you need to install an SSR and use it to turn on and off the positive leg of your 115 VAC line. That should get you going. If you look at the supplied DWG of the wiring diagrams at the top they are specifically calling for SSR's on the TA-4 drawing. Hope this helps.

Wheelchair Bob
What do you mean "no Kidneys"???, WTF now I gotta drink less beer...
Join the Automation sub forum in Electric brewing for a discussion of components and control systems. I did!!!!

Reply With Quote
Thread Tools

Similar Threads
Thread Thread Starter Forum Replies Last Post
Any good alternatives to Pt100 RTD ? theQ Electric Brewing 27 02-05-2013 05:32 PM
Another 3-wire/4-wire question (sorry) PopNLochNessMonsta Electric Brewing 5 10-13-2012 12:45 AM
Connecting a Three wire inline GFCI to a 4 wire Outlet? ODI3 Electric Brewing 3 10-10-2012 03:02 PM
4-wire GFCI 220 volt cable with a 3-wire dryer outlet? gshopper Electric Brewing 12 07-17-2012 11:49 PM
How-To: Pt100/RTD 1/2" NPT Thermowell PaulHilgeman Kettles, Mash Tuns & Hot Liquor Tanks 12 05-11-2011 10:12 PM

Forum Jump