theotheragentm
Member
Is there a way to bleed off pressure through a pin lock relief valve or do I have to do it through the inlet post? I wasn't sure if there was some kind of tool to do it.
Pin Lock Relief Valve
- Thread starter theotheragentm
- Start date
Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:
Geiger420
Active Member
if you do not have a valve in the lid you need to bleed it through the co2 post. use a screw driver or a knife and press the center of the post to put down on the spring.
- Joined
- Jan 18, 2011
- Messages
- 3,032
- Reaction score
- 283
OP
OP
theotheragentm
Member
I've seen the product in the link, but they say it's for bleeding off on a post, not the relief valve, or am I reading it wrong?
Johnnyhitch1
Well-Known Member
switch the liquid-out hose to the gas-in post and bleed thru your tap, swap back and enjoy!
OP
OP
theotheragentm
Member
Brilliant. That's not too much wear and tear on the faucet?
What - from beer and CO2? You're talking about the two things that the faucet is built to handle. I think it'll be ok
It'd work, but honestly that's a lot more involved than just pressing down on the In poppet...
Cheers!
Similar threads
