smarch0
Well-Known Member
What was the final measurement of spacing between the freezer and your framing? I am starting to design my own spin-off of your build.
I measured it at 1-1/2" and it is just enough room, you might want to go 1-3/4" to be safe. Took me a while to figure out how to get them installed right. I think the best way is with the lid open screw in the lower end near the back, then just lift the upper end and screw it in where ever it meets your lid framing (with the piston fully extended).
Be sure to post a link if you post it on here.
Good luck!
Smarch