Hello,
I have a current single kegging setup with all 5/16" air hoses/clamps. I am adding a second keg, splitting the CO2 with a Y-connector. All my local shops seem to stock 1/4" ID air line fittings (Ball lock hookups with 1/4" ends, line barbs, connectors, etc.)
Given that I will be using the exact same set-it-and-forget-it PSI of 12 for both kegs, is there any problem with using 5/16" CO2 line on one keg and 1/4" line on the other? I assume pressure is pressure but want to make sure. Both kegs use the same beer line so no issues there....
Any advice is appreciated.
Thanks!
I have a current single kegging setup with all 5/16" air hoses/clamps. I am adding a second keg, splitting the CO2 with a Y-connector. All my local shops seem to stock 1/4" ID air line fittings (Ball lock hookups with 1/4" ends, line barbs, connectors, etc.)
Given that I will be using the exact same set-it-and-forget-it PSI of 12 for both kegs, is there any problem with using 5/16" CO2 line on one keg and 1/4" line on the other? I assume pressure is pressure but want to make sure. Both kegs use the same beer line so no issues there....
Any advice is appreciated.
Thanks!