StarvinMarvin
New Member
Hi all,
As you can see I am new to the forum. I'm pretty new to forums in general, and don't have much computer experience, so please bear with me.
I've been brewing beer for a few years (gradually getting better) and I would like to build up a better system. I was thinking about building a system such as this one:
Could any of you let me know what you think about the equipment shown? Specifically I'm wondering if there are alternatives to the temperature controller (e.g. other similar models that might be either higher quality or lower price). Also, might you have any suggestions for a good low cost pump?
Thanks in advance. Happy Holidays.
Marv
P.S. I also had a question about the head of some of my beers. They occasionally get very thin and break up into small floaters/islands. Do any of you know what causes that, or how it could be prevented? I'd like to post a picture, but can't figure out how. Is that possible, or do you know what I'm talking about?
As you can see I am new to the forum. I'm pretty new to forums in general, and don't have much computer experience, so please bear with me.
I've been brewing beer for a few years (gradually getting better) and I would like to build up a better system. I was thinking about building a system such as this one:
Could any of you let me know what you think about the equipment shown? Specifically I'm wondering if there are alternatives to the temperature controller (e.g. other similar models that might be either higher quality or lower price). Also, might you have any suggestions for a good low cost pump?
Thanks in advance. Happy Holidays.
Marv
P.S. I also had a question about the head of some of my beers. They occasionally get very thin and break up into small floaters/islands. Do any of you know what causes that, or how it could be prevented? I'd like to post a picture, but can't figure out how. Is that possible, or do you know what I'm talking about?
Last edited by a moderator: