I cant weld. What is the best way/material to use to make a sturdy brew stand that would be no-weld. I was thinking unistrut or something like that. I would like to avoid wood if possible.
Thanks.
Thanks.
I am building mine out of old bed frames get a colbalt drill bit and 1/4 inch x 1/2 bolts and lock nuts, its really pretty strong and later if I decide to make mods to it I just unbolt. I have 3 kegs and getting a couple pumps heres mine so far
Angle grinders are for grinding, not cutting. With that out of the way, Ive used mine to cut. Just make sure you are wearing eye protection! Practice cutting on some spare scrap so you get the idea of how to use it. Also, when you are doing this, you will creat a TON of heat so dont go touching the metal for a few mins after
Then why do they manufacture and sell abrasive wheels specifically labeled and sized as cut-off wheels for angle grinders?
I work at a metal fab company and we use angle grinders to cut/trim ALL THE TIME!
I guess the wheel I have is only for grinding then because it says all over it, for grinding only.
Thanks for putting me in my place.
Did you just cut the frame with an angle grinder? I just bought my first angle grinder. Any tips for safely cutting the frame?
Enter your email address to join: