Well, my equipment is hardly anything special. A friend who came by to help move some stuff peaked under the white sheet that protects my brew stuf from dust, and promptly asked when the next meth cooking session was happening.
Maybe my lauter technique has something to do with it. Here's the process:
I draw a gallon to a gallon and a half of wort into a holding pot, then slowly add it back to the tun. this clears out all the junk. All the while my sparge water is heating to about 185/190. I know that sounds too hot, but read on. I start lautering pretty slowly and bail sparge water into the tun with a small sauce pot. I pour slowly, but I constantly move the spot where I am pouring around the tun to make sure all grains are rinsed. The water level in the tun stays around 1/2 inch above the grains when I have the outflow set right. The grains stir around a bit, but that doesn't seem to disturb the bottom, filtering part. I keep a thermometer in the tun to monitor temp and strive for exactly 170. If the temp drops, I speed up the lautering and bailing a little so the hotter sparge water heats things back up. If the temp get's over 170 at all, I stop the lauter and wait for it to drop. Which doesn't take long if it's caught right away. About half way through, I shut off the lauter and stir the heck out of the tun. Then I draw a gallon or so off to clear it again, and go back to lautering. On the last batch I did my best to leave as little fluid in the tun as possible by stopping the water additions about a gallon before the boil pot was full. I know this sounds like a lot of crap to go through, but what else have I got to do? It's a little boring just sitting there watching. I am curious to try skipping the stirring in the middle and see if the efficiency goes up or down.
The only other thing I do, that most don't, is a dough-in around 100 degrees for about an hour. It's not necessary but I like to think it helps by letting everything get good and wet throughout. It also gives me time to get everything set and ready to go for all the steps that follow. Ya know like drinking a beer or three.....
BTW I just couldn't help it, and chilled another of my first batch to sip on today while crushing grains for tomorrow's stout brew and it just keeps tasting better and better. THANKS again to everybody!