I scored an XL freezer and 10 corney kegs from CraigsList this week and want to finish the collar while waiting the arrival of all my gear.
1) I have 8 shanks and 7 Perlick faucets (Saving 1 for a Nitrogen setup) coming in and hope to build the collar while waiting. Searching here on HBT I've found that I want to drill 1" holes. How far should I space the holes?
2) I had originally planed to run 8 kegs, and put the regulator on the "hump". Because I'm using the shorter pin-lock kegs, the collar allows me to put a keg there. Should I use the hump for an additional keg or other cold storage and put the tank outside? (I've read the inside/outside articles and get it that it doesn't matter - I"m just looking for comments if this were your setup).
$75 Freezer & $20ea corney kegs.
First coat of paint, and the start of a Collar
1) I have 8 shanks and 7 Perlick faucets (Saving 1 for a Nitrogen setup) coming in and hope to build the collar while waiting. Searching here on HBT I've found that I want to drill 1" holes. How far should I space the holes?
2) I had originally planed to run 8 kegs, and put the regulator on the "hump". Because I'm using the shorter pin-lock kegs, the collar allows me to put a keg there. Should I use the hump for an additional keg or other cold storage and put the tank outside? (I've read the inside/outside articles and get it that it doesn't matter - I"m just looking for comments if this were your setup).
$75 Freezer & $20ea corney kegs.
First coat of paint, and the start of a Collar