Axegod
Well-Known Member
Hello,
I would appreciate any advice on the slot cutting portion of constructing a copper manifold for a cooler.
I have the cooler, and will measure, etc..but from most posts and other sites,
I have seen a hacksaw used...very time consuming.
Any other suggestions (dremmel rotary tool?) to cut dozens of small slots?
Or should I just start hackin' away?
Signed,
Lazy.
I would appreciate any advice on the slot cutting portion of constructing a copper manifold for a cooler.
I have the cooler, and will measure, etc..but from most posts and other sites,
I have seen a hacksaw used...very time consuming.
Any other suggestions (dremmel rotary tool?) to cut dozens of small slots?
Or should I just start hackin' away?
Signed,
Lazy.