I'm having a problem with the regulator screw not wanting to turn past a certain point. I had the regulator on 20 psi carb'ing a keg. I then lowered the pressure to seal another keg. Now I can't get the screw to turn in more than past the 10-12 psi mark. I had this same trouble when I first got the regulator and hooked it up. Although I unscrewed and screwed it back in enough that it eventually went back in further. Is it possible to get the screw threaded wrong if it's turned too loose?
I've disconnect the reglator from the keg and bottle and letting it sit out to warm up for a bit. Wondering if this might be some how due to the regulator being cold from being in the fridge with the keg.
I've disconnect the reglator from the keg and bottle and letting it sit out to warm up for a bit. Wondering if this might be some how due to the regulator being cold from being in the fridge with the keg.