jlaureanti
Well-Known Member
- Joined
- Nov 25, 2010
- Messages
- 121
- Reaction score
- 1
Hello,
So after looking at as many sculptures as i could throughout the forum I decided I could build my own. My friend donated all the 1/4" angle iron and did the welding for me too. I made a few welds but he did the majority. His neighbor also happened to be a metal artist and had a plasma cutter on hand. He offered to cut my kegs for me and he even wrote my name in the keg handle for me (seen below)
I apologize for the lack of build picks... I was lost in the moment...
There are two burners, but only the bottom burner is stationary. The burner on the second tier can move to the top tier.
Cuts are still rough
The ..almost.. finished product :rockin:
It is not 100% complete, but there is always room for upgrades...
So after looking at as many sculptures as i could throughout the forum I decided I could build my own. My friend donated all the 1/4" angle iron and did the welding for me too. I made a few welds but he did the majority. His neighbor also happened to be a metal artist and had a plasma cutter on hand. He offered to cut my kegs for me and he even wrote my name in the keg handle for me (seen below)
I apologize for the lack of build picks... I was lost in the moment...
There are two burners, but only the bottom burner is stationary. The burner on the second tier can move to the top tier.
Cuts are still rough
The ..almost.. finished product :rockin:
It is not 100% complete, but there is always room for upgrades...