MX1
Texas Ale Works
I ordered the EKC from High Gravity because I am not very good with wiring stuff up...
It comes ready for 240v but has an American style dryer cord for the power supply see below
this as you may know will not work with my European 240v plugs. I currently have a 30amp breaker box wired up for a heat stick that works well, below is the box
Here is the inside of the EKC ( Electric Kettle Controller)
Now from my very limited understanding, I have 2 "hots" and a ground going into my breaker, from looking at the dryer cord the 2 "blade" style prongs should be "hot" and the "bent" prong should be the ground. That translates into the 2 outside leads being "hot" with the center being the ground.
So, in theory, I should be able to do a 1 for 1 swap with the wires coming out of the breaker box correct. 1 hot to the on/off switch, one hot and a ground to the plug.
Am I even close?
thanks
Tim
It comes ready for 240v but has an American style dryer cord for the power supply see below
this as you may know will not work with my European 240v plugs. I currently have a 30amp breaker box wired up for a heat stick that works well, below is the box
Here is the inside of the EKC ( Electric Kettle Controller)
Now from my very limited understanding, I have 2 "hots" and a ground going into my breaker, from looking at the dryer cord the 2 "blade" style prongs should be "hot" and the "bent" prong should be the ground. That translates into the 2 outside leads being "hot" with the center being the ground.
So, in theory, I should be able to do a 1 for 1 swap with the wires coming out of the breaker box correct. 1 hot to the on/off switch, one hot and a ground to the plug.
Am I even close?
thanks
Tim