Hilbert
Well-Known Member
- Joined
- Jan 22, 2009
- Messages
- 187
- Reaction score
- 3
Every CPVC manifold I have seen on this site has slits cut into it with a sawzall or jigsaw.
What I would like to know before I build my manifold is there a reason why everyone uses slits and not small holes?
My thought is that there is a fear of stuck sparges but I would think if there are enough holes and the maifold is upside down it wouldn't be a problem.
Any thoughts on this?
What I would like to know before I build my manifold is there a reason why everyone uses slits and not small holes?
My thought is that there is a fear of stuck sparges but I would think if there are enough holes and the maifold is upside down it wouldn't be a problem.
Any thoughts on this?