-MG-
Well-Known Member
I have a Frigidaire 7.2 that I just built a collar for and will be mounting that to the hinges that were on the lid and securing the top to the collar.
I'm currently debating building a DIY tower versus just putting the faucet in the collar like so many have done. What are people's feelings on the two? My biggest thing against the collar is that I don't like how low it seems to be. You practically have to bend over to pour a beer.
I found a thread a while back where a guy said all the negatives of it. Like moving it away from the wall everytime you want to open it (would have to do that anyway with the way I want the collar setup). Hard to clean the lines. Not sure I agree because seems like I could just have a keg full of some sort of oxy clean and run it through the lines to clean them.
For the tower I was going to encase the beer lines in soft copper up the tower with insulation.
I'm currently debating building a DIY tower versus just putting the faucet in the collar like so many have done. What are people's feelings on the two? My biggest thing against the collar is that I don't like how low it seems to be. You practically have to bend over to pour a beer.
I found a thread a while back where a guy said all the negatives of it. Like moving it away from the wall everytime you want to open it (would have to do that anyway with the way I want the collar setup). Hard to clean the lines. Not sure I agree because seems like I could just have a keg full of some sort of oxy clean and run it through the lines to clean them.
For the tower I was going to encase the beer lines in soft copper up the tower with insulation.