Just finished my kegerator, it's looking pretty good. I have one problem. I installed the draft tower and the part the faucet connects to is loose. I can't seem to get it tightened. Do I need to take it off the kegerator and somehow get up inside it to tighten the part? Any help will be appreciated! Thanks!
Kegerator finished, but ...
- Thread starter dylan8678
- Start date
Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:
If I'm understanding you correctly, this is what you need: http://www.austinhomebrew.com/product_info.php?products_id=1258
boldone
Well-Known Member
I had the same problem. I just removed the top (you may need to pry it off carefully with a small screwdriver) and with the tap on, I held the inside and cranked it tight. I did not need a wrench. After it is cranked down tight, remove the tap and realign it and tighten it up.
EdWort
Well-Known Member
Yeah, a Spanner Wrench is what you need. AHBS doesn't have a pic, so here's one.
