As long as your O2 pressure is lower than your pump output pressure, it'll work just fine. You may see some serious foaming going into the fermenter.
MC
I'm sure it must be obvious, but how does it work?
Great idea! So how are you going to clean it and sanitize it? Do you have to take off the compression fitting after every brew? Pull it out.
Coud you go with a tee on one the end where the elbow is? Plug the end that is inline with the stone and then all you would have to do is loosen the compression nut and slid the stone out through the tee.
Where did you get the stone with the SS wand on it?
Oh... I assumed you used the 2 silicone o-rings method. Once you clamp that furrel down, that's all she wrote!
Enter your email address to join: