CidahMastah
Well-Known Member
- Joined
- Nov 12, 2010
- Messages
- 4,201
- Reaction score
- 46
Here is the scoop:
I am trying to find out if anyone has ever cut another hole in their stainless tower for adding another faucet. Currently I have a KC dual tap tower and I am considering cutting a third hole in it so I can make it a three faucet tower.
I was considering going the greenlee punch method becuase the tower is fairly curved. I think drilling with a step bit may be a challenge.
1. Has anyone done this successfully?
2. Do you know the size needed for the hole? (15/16 or 1'')
This would be a great way to cut some cost out for people who would like to expand their towers from one, to two or three.
Thanks!
I am trying to find out if anyone has ever cut another hole in their stainless tower for adding another faucet. Currently I have a KC dual tap tower and I am considering cutting a third hole in it so I can make it a three faucet tower.
I was considering going the greenlee punch method becuase the tower is fairly curved. I think drilling with a step bit may be a challenge.
1. Has anyone done this successfully?
2. Do you know the size needed for the hole? (15/16 or 1'')
This would be a great way to cut some cost out for people who would like to expand their towers from one, to two or three.
Thanks!