tips for fridge conversion for draft setup
- Thread starter JayWeezie
- Start date
Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:
runs4beer
Well-Known Member
- Joined
- Feb 9, 2010
- Messages
- 412
- Reaction score
- 22
I just picked my spot (you'll want to take your time and think this through) hit it with a center punch and drilled with a hole saw as soon as your through the outer sheet metal stop and get it out of the hole saw so its not pushed to the back. Should be no problem.
two_hearted
Well-Known Member
Make sure the shank and tubing isn't going to hit anything and drill baby drill. Maybe take a few practice pulls to ensure the height is optimal for beverage service.
