I know that there are other posts about this, but they don't seem to follow with the schematic of my controller. I just want to use an extention cord, not splice into the compressor relay. I have a TS-13010 that looks like this:
7-Power Supply
8-Power Supply
9-NC (means normally closed i believe)
10-COM (means common i believe)
11-NO (means Normally Open i believe)
i have an extention cord:
green - ground
white- common
black-hot
I think that I leave the ground and common alone and splice the Hot from wall --> com
NC --> fridge
my question is what do I do with 7 and 8 then?
7-Power Supply
8-Power Supply
9-NC (means normally closed i believe)
10-COM (means common i believe)
11-NO (means Normally Open i believe)
i have an extention cord:
green - ground
white- common
black-hot
I think that I leave the ground and common alone and splice the Hot from wall --> com
NC --> fridge
my question is what do I do with 7 and 8 then?