ddahl84
Well-Known Member
Using Auber pid 2352
I just finished building a control panel and everything seems to be working correctly except when setting the alarm on the pid it doesn't trigger the buzzer that its connected to. Looking over and over at the wiring everything seems to be ok. I have hot connected to pin 13, then pin 1 going to one side of the buzzer and neutral going to the other side of the buzzer. When setting the alarm on the pid a little led comes on in the upper left corner suggesting it is working and i can here it click but why would the buzzer not go off? I have tested the buzzer separately and it does work. Am I missing something here or is the relay in the pid broken? Any feedback would be appreciated. Thanks
I just finished building a control panel and everything seems to be working correctly except when setting the alarm on the pid it doesn't trigger the buzzer that its connected to. Looking over and over at the wiring everything seems to be ok. I have hot connected to pin 13, then pin 1 going to one side of the buzzer and neutral going to the other side of the buzzer. When setting the alarm on the pid a little led comes on in the upper left corner suggesting it is working and i can here it click but why would the buzzer not go off? I have tested the buzzer separately and it does work. Am I missing something here or is the relay in the pid broken? Any feedback would be appreciated. Thanks