Dwain
Well-Known Member
Hey Guys,
I plan on using 1/2" stainless for my HLT coil. I am building a single tier system with converted kegs. What length does my coil need to be to get the best heat exchange. I know that it depends on flow rate but I'm looking for good rule of thumb. I've seen people use 50' of copper but I have no idea on stainless. I'm off to the shop to finish my welds and scrub up, so I'll check this post later. Thanks for the help.
I plan on using 1/2" stainless for my HLT coil. I am building a single tier system with converted kegs. What length does my coil need to be to get the best heat exchange. I know that it depends on flow rate but I'm looking for good rule of thumb. I've seen people use 50' of copper but I have no idea on stainless. I'm off to the shop to finish my welds and scrub up, so I'll check this post later. Thanks for the help.