How to Convert Coolers

The coolers I have, have plastic push button spigots. How can I remove these and add the ball valves I see on the ones that home brew stores sell?

And where can I get the ball valves, bulkheads, etc?

Thanks

read this thread...https://www.homebrewtalk.com/f51/cheap-easy-10-gallon-rubbermaid-mlt-conversion-23008/

You can also use the project locator in the DIY section, good stuff in there:
https://www.homebrewtalk.com/f51/project-locator-69953/

You can buy pre-made cooler inserts for a variety of wall thicknesses from various retailers. Bargain Fittings is a vendor here, and his prices are the best I've seen. Bargain Brew Fitting Home Page

If you use these parts from Lowes, you can do it easy.

From INSIDE to OUTSIDE:

(1) 1/2" x 1/2" FPT x Barb female adapter
(1) 3/4" SS flat washer
(1) 1 1/8" OD x 5/8" ID Rubber grommets (for inner and outer seal)
(1) A-836 1/2"MIP x 1 1/2" Brass pipe nipple
(1) 1 1/8" OD x 5/8" ID Rubber grommets (for inner and outer seal)
(1) 3/4" SS flat washer
(1) 1/2" threaded ball valve
(1) 1/2" x 1/2" MPT x barb Male adapter

Was about $15. You can attach a braid or false bottom at will on the inside.

Wow, Denny, I didn't know you came around this neck of the woods! I lurk on all the other forums, and just wanted to say thanks for popularizing such a good piece of gear!

If I can help people make better beer, that's what it's all about!