Tarheel4985
Well-Known Member
Getting ready to order beer and gas lines for my keezer and was just wondering if there was any reason I shouldn't order these:
3/16 ID 5/16 OD for the beer line:
McMaster-Carr
1/4 ID 3/8 OD for the gas line:
McMaster-Carr
I know most people go with 7/16 OD for the beer line, but I'll be using 10' per keg so would I avoid foaming issues because of length even with less resistance? This line was less than half the cost of the 7/16 ($0.11/ft).
As for the gas line, is there any problem with this choice? I assumed the ID and OD don't matter as much as for the beer line, but I have 1/4" gas disconnects for the keg.
If these won't work I'd appreciate someone pointing me in the right direction. I'm trying to keep costs as low as possible but I don't want to sacrifice quality. Thanks in advance.
3/16 ID 5/16 OD for the beer line:
McMaster-Carr
1/4 ID 3/8 OD for the gas line:
McMaster-Carr
I know most people go with 7/16 OD for the beer line, but I'll be using 10' per keg so would I avoid foaming issues because of length even with less resistance? This line was less than half the cost of the 7/16 ($0.11/ft).
As for the gas line, is there any problem with this choice? I assumed the ID and OD don't matter as much as for the beer line, but I have 1/4" gas disconnects for the keg.
If these won't work I'd appreciate someone pointing me in the right direction. I'm trying to keep costs as low as possible but I don't want to sacrifice quality. Thanks in advance.