EuBrew
Well-Known Member
I think I've finally figured out the wiring for this but can someone please verify my drawing below?
Brewtroller has a 3 pin header designed to wire to a SPDT switch.
The three pins are
1 brewtroller (auto control)
2 Relay (activates relay for device)
3 is ground.
The BrewTroller brings all of it's output to ground when they are "ON", so do I have this figured out finally???
Brewtroller has a 3 pin header designed to wire to a SPDT switch.
The three pins are
1 brewtroller (auto control)
2 Relay (activates relay for device)
3 is ground.
The BrewTroller brings all of it's output to ground when they are "ON", so do I have this figured out finally???