gonzo brewer
Well-Known Member
OK, Got 2 AG's under my belt. All went well, but I was low on my SG's by 15 and 10 points. My FG's were also low by a little.
My guess, not a good enough crush, and maybe mash temps were a little lower than needed, which explains the lower FG's.
I just purchased (3) 5 gal batches worth of grains and will start brewing tomorrow. I had the grains crushed at my LHBS, and they appear to be crushed adequately.
I also picked up a knock-off of a corona mill. Dieing to try it out.
Should I try to run the grain thru for another crush? Or should I just focus on getting my mash temps right. I will batch sparge.
My guess, not a good enough crush, and maybe mash temps were a little lower than needed, which explains the lower FG's.
I just purchased (3) 5 gal batches worth of grains and will start brewing tomorrow. I had the grains crushed at my LHBS, and they appear to be crushed adequately.
I also picked up a knock-off of a corona mill. Dieing to try it out.
Should I try to run the grain thru for another crush? Or should I just focus on getting my mash temps right. I will batch sparge.