Harvestsmiles
Well-Known Member
I read that there is no pressure relief valve on pin locks and to purge the corny keg it is easiest to push in the center of the gas inlet side post. Well I tried that but my keg was full and I got sprayed...With further reading I found that you can cut the stem so that it will not be submerged in the beer and will not spray liquid only air.
My ? is what is the best way to cut the stem? I was thinking with a pipe cutter like that you would use for cutting copper pipe...I currently have a keg full with Rye P.A. so I won't be doing it until the keg is empty...
My ? is what is the best way to cut the stem? I was thinking with a pipe cutter like that you would use for cutting copper pipe...I currently have a keg full with Rye P.A. so I won't be doing it until the keg is empty...