barnbrew
Member
I'm just putting the finishing touches on my RIMS system. I've had lots of useful ideas from this forum, it's been a great resource of info. Here's my dilema, I want to wire up my heat stick using Sawdust guys "RIMS for dummies" circuit and bill of materials. I have a March pump that I would like to plug into a GF outlet I've wired down below on my frame. I have a motor switch that is in my panel, just a toggle on off type just like a light switch but rated for motor use. I also have a power cord with plug coming out of the panel. My questions are:
1. How do I wire up the GF plug into my switch?
2. Does this Auber PID have a separate on off switch or do I need an additional one?
3. Is there a second terminal strip outside of the panel that the SSR goes into?
1. How do I wire up the GF plug into my switch?
2. Does this Auber PID have a separate on off switch or do I need an additional one?
3. Is there a second terminal strip outside of the panel that the SSR goes into?