Control panel too small...

BrewSwag 728
Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum

Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
CoalCracker

CoalCracker

Well-Known Member
Joined
Sep 3, 2009
Messages
1,654
Reaction score
106
Location
Macungie, Pa
After installing all the lights, switches, and both PIDs in my panel, I think it is too small to fit all the components inside. I underestimated the size of the contactors. Instead of redoing everything, can I install the contactors in a separate panel? Then just run the wiring through some conduit to connect the two. I would hate to have to spend more money and time to redo it.
 
You could put the contactor in a seperat box and run wires pretty easilly. That was whatt I was planning to do until a freind in the sheet metal trade built me a box that fits into my space perfectly. Don't need to break them up mow.
Bob
 
Yea I would hate to spend another 100 or so on a larger panel. Plus the time it takes to lay everything out and drill all the holes. I can run that separate panel to a remote location on the stand.
 

Similar threads

schwartzr33
Auber SYL-2352 Problem
Replies
15
Views
864
shoengine
shoengine
David Coy
Power 1 and/or 2 Anvil Foundries at 240 from a 30 amp 240 spa panel
Replies
4
Views
622
David Coy
David Coy
B
eBIAB PID Controller Wiring Diagram - Feedback Requested
Replies
14
Views
1K
beerisambrosia
B
wmubronco
For Sale 15/20 gallon KAL clone 240V 50A system - Metro Detroit, MI
Replies
3
Views
507
wmubronco
wmubronco
B
For Sale (IN) ebrewsupply I assembled kit, keggles, soldered fittings
Replies
3
Views
765
brum
B

Latest posts

Back
Top