Broncobum
Well-Known Member
as I was roaming around the depot with element in hand trying pvc parts and whatnot, I came upon this guy:
It is slip fit 1" on one side, and threaded 1/2" on the other. the slip fit is snug around the back of the element, and I threaded a 1/2" electrical compression fitting into the other.
I drilled a hole on the inside crook of the elbow to let the ground wire out. A little silicone to keep everything sealed and in place and it is done.
It is slip fit 1" on one side, and threaded 1/2" on the other. the slip fit is snug around the back of the element, and I threaded a 1/2" electrical compression fitting into the other.
I drilled a hole on the inside crook of the elbow to let the ground wire out. A little silicone to keep everything sealed and in place and it is done.