OsbornBrewing
Well-Known Member
Installed my first faucet on the collar of my keezer today, and when I connect it to the beer out on the keg, I get foam shooting out the shank nut holes, not sure if that is right term. The faucet connects to the shank, and on the shank is the rounded nut with holes in it for tightening, I am getting beer out of those holes.
Any ideas? Neither the faucets nor the shanks came with a washer or gasket, and this seems a good spot for one, am I right?
Any ideas? Neither the faucets nor the shanks came with a washer or gasket, and this seems a good spot for one, am I right?