brewskiman
Active Member
my beer hose to my coupler is leaking beer. i have a 90 degree elbow connected to my coupler. an then the hose connected to the 90 degree elbow thats connected to the coupler its leaking drips of beer right where the clamp is on the beer hose connected to the 90 elbow that goes to the coupler. i disconnected the coupler from my keg and its still in my keezer staying cold. i am worried that my keg will go flat since its not connected to my co2 tank since its leaking. do you think it will go flat or no?? sry i am a newbie this is my second keg. when i lifted the keg into my keezer the line was on the bottom and i think i may of crused my clamp that screws onto the coupler. do you think i need to replace my clamp or the thing that screws onto the coupler???
its not leaking a lot but drips of expensive beer i don't want to waste so i took my cooler off and turned off my co2 tank is that fine until i get it fixed. aim really worried the keg will go flat since the co2 is not hooked up to the keg and its just sitting in my keeper staying cold. is that fine?
its not leaking a lot but drips of expensive beer i don't want to waste so i took my cooler off and turned off my co2 tank is that fine until i get it fixed. aim really worried the keg will go flat since the co2 is not hooked up to the keg and its just sitting in my keeper staying cold. is that fine?