JacksSpleen
Active Member
Here is my contribution to hundreds of Keezer builds out there. I used ¾ x 7 ¼ MDF for the collar and 1 inch pink insulation to keep it cold (I didnt think about moisture and MDF until I had put it together
ooops! I figure I can replace it cheap enough if the MDF suffers) I had to go with this 5.1 due to the space SWMBO had given me. BTW this freezer is W 27 ¼ X D 19 ½ X H 32 ¾ and comes with little casters on the bottom. The Sears website does not give accurate dimensions on this model. As you can see Im able to pack in 3 pinlock kegs into this little dude with the co2 tank on the outside. I have a 20 pound tank in the closet and also a little 2.5 pounder that will fit inside if I ever want to make mobile. I had to offset the faucets because the keg that sits on the hump is too tall. I do have to remove the middle keg to get the one on left in and out because of the shanks which Im sure will be PITA when I have to load full keg in. But not bad considering the space I had to work with. Im open to any suggestion or criticism with this build. Im looking to make the best I can.