dandw12786
Well-Known Member
Hi all,
I've got a kegerator that I typically have two cornies and a 5# CO2 tank in, and am looking to get a little setup going to be able to get a 1/6bbl keg of commercial beer when i'm out of homebrew (these winter months make it a bit tough to brew outside...). I've searched the forums, and know I'm not the first person to do this, but can't seem to find the answer to my question. I'm wondering how far the standard Sanke Coupler sticks out above the keg? My kegerator measures 29", so if it fits, it'll be tight, but i'm wondering if it's doable.
I'm aware of the low clearance couplers, but they're more expensive right off the bat, and converting them to be able to hook to my pin lock connections (I can't seem to find anyone that's hooked them up to quick disconnects) is way more expensive than converting the standard taps.
Anyone have a Sanke Coupler they can measure? Thanks!
I've got a kegerator that I typically have two cornies and a 5# CO2 tank in, and am looking to get a little setup going to be able to get a 1/6bbl keg of commercial beer when i'm out of homebrew (these winter months make it a bit tough to brew outside...). I've searched the forums, and know I'm not the first person to do this, but can't seem to find the answer to my question. I'm wondering how far the standard Sanke Coupler sticks out above the keg? My kegerator measures 29", so if it fits, it'll be tight, but i'm wondering if it's doable.
I'm aware of the low clearance couplers, but they're more expensive right off the bat, and converting them to be able to hook to my pin lock connections (I can't seem to find anyone that's hooked them up to quick disconnects) is way more expensive than converting the standard taps.
Anyone have a Sanke Coupler they can measure? Thanks!