DoubleAught
Well-Known Member
I've decided that I'm going to install four taps on my beer fridge. After looking at all the hardware needed I'm not sure if I know what the hell I'm doing and am looking for a little advice.
Currently I have four pin lock kegs. I use two at a time now with a duel regulator system and picnic taps.
What I currently have picked out is as follows...
4x - 5-1/8" Shank with Faucet Assembly....do I need a nipple shank?
4x - Coupling Nut, Tail Piece Nipple , Washer for Beer Line
20' - 5/16" CO2 Pressure Hose - Red
2x - 2-way Manifold (for use on each regulator)
40' - 3/16" Beer Line Clear, Beer Hose
Am I missing anything? I'm looking at more beer hose than I probably need but wanted extra on each keg to limit the amount of foam, good or bad?
Thanks for any advice. I was looking at buying a kegerator, but the cheapest was 600 for two taps, this is half that and I get four.
Thanks again...
Currently I have four pin lock kegs. I use two at a time now with a duel regulator system and picnic taps.
What I currently have picked out is as follows...
4x - 5-1/8" Shank with Faucet Assembly....do I need a nipple shank?
4x - Coupling Nut, Tail Piece Nipple , Washer for Beer Line
20' - 5/16" CO2 Pressure Hose - Red
2x - 2-way Manifold (for use on each regulator)
40' - 3/16" Beer Line Clear, Beer Hose
Am I missing anything? I'm looking at more beer hose than I probably need but wanted extra on each keg to limit the amount of foam, good or bad?
Thanks for any advice. I was looking at buying a kegerator, but the cheapest was 600 for two taps, this is half that and I get four.
Thanks again...