lotbfan
Well-Known Member
Oh, for anyone following this and making their own, i popped out the little plug in the back of the lid, drilled a hole in the plastic towards the back center of the lid, and that made a nice hole to feed the temp probe through. I didn't really bother insulating the hole that I knocked out of the ceiling, as I don't see a lot of cold air rising up and out of it, but it does save the drill and spray foam step.
For a finished outside look, I drilled out the tiny center hole a little bit, and made a small 1mm wide cut to the center so I could slide the wire into it.
Going to pull the trigger on the fan, thanks again.
For a finished outside look, I drilled out the tiny center hole a little bit, and made a small 1mm wide cut to the center so I could slide the wire into it.
Going to pull the trigger on the fan, thanks again.