spitfire
Well-Known Member
Ok, I am going to put my order in for my keezer build and want to make sure I am not missing anything. To note, I will be doing a 4 tap keezer but might only buy enough to setup 2 taps to start due to lack of funds so please keep that in mind when reviewing my list.
Cornies(pepsi)
I will be getting 4 of these for free.
First thing I will do is clean then and replace the O rings
Anything else I should replace while I am at it?
Are there any other fittings or hardware that I will need to use these?
Taps
2 faucets
2 wing nuts for faucets
2 shanks (what is the average length to use? I will be making a custom wood tower and the wood will only be 3/4" thick)
Do I need anything else in regards to the faucets? any other fittings needed?
Gas
I will be doing 2 (eventually 4) cornies. I want to use 1 regulator and 5# tank.
I was going to use
wye splitter
2 stainless T's
I guess I will need shutoff for each line as well right? Which makes me wonder, would it just be easier and cheaper to start with a 4 way distributor for 50 bucks?
If I use the wye splitter but only use a single keg to start how will I control the gas to that section? I would need a shutoff valve on each part of the wye splitter right?
I know I will need tubing but I am not that concerned about that right now as I plan to just buy that locally.
I read through a lot of pages in the kegging section and couldn't find all the answers so I thought I would post. I really don't want to order only to have to order again.
Cornies(pepsi)
I will be getting 4 of these for free.
First thing I will do is clean then and replace the O rings
Anything else I should replace while I am at it?
Are there any other fittings or hardware that I will need to use these?
Taps
2 faucets
2 wing nuts for faucets
2 shanks (what is the average length to use? I will be making a custom wood tower and the wood will only be 3/4" thick)
Do I need anything else in regards to the faucets? any other fittings needed?
Gas
I will be doing 2 (eventually 4) cornies. I want to use 1 regulator and 5# tank.
I was going to use
wye splitter
2 stainless T's
I guess I will need shutoff for each line as well right? Which makes me wonder, would it just be easier and cheaper to start with a 4 way distributor for 50 bucks?
If I use the wye splitter but only use a single keg to start how will I control the gas to that section? I would need a shutoff valve on each part of the wye splitter right?
I know I will need tubing but I am not that concerned about that right now as I plan to just buy that locally.
I read through a lot of pages in the kegging section and couldn't find all the answers so I thought I would post. I really don't want to order only to have to order again.