eroth
Active Member
I racked to secondary yesterday, and the stopper on the secondary, over time, always seems to slip up and out.
I had used StarSan to sanitize both the carboy and the stopper, so I'm sure this is the culprit...but does anyone know any tricks for getting them to stay in place properly?
I doubt anythings going to get in through the tiny crack it creates when it pops out, but better safe than sorry...
I had used StarSan to sanitize both the carboy and the stopper, so I'm sure this is the culprit...but does anyone know any tricks for getting them to stay in place properly?
I doubt anythings going to get in through the tiny crack it creates when it pops out, but better safe than sorry...