snb778
Member
I don't believe for probably 7-8x 1/6 barrel kegs i've had in this thing have I been able to get it to pour properly unless I have the pressure at about 1-2psi (where it just about trickles out).
I've tried hose lengths from 3ft to 5 ft. did not change. The line looks clear of foam, but the second I start to pour, I get 50+% foam cups just about every time. I've got a feeling its because of the tap fitting
I literally had to heat up and stretch the end of the hose to fit around the fitting on top of my sankey
The tap hole is only about 1/8" wide where I have a 3/8" hose which goes to my sankey which is a 1/4" fitting (gettin 1x 3/8" hose around 2 different sized fittings is very difficult)... Here is the sankey I have with the same fitting
I believe i'm essentially pinching the beer as it goes up the line... What can I do to correct this?
I've tried hose lengths from 3ft to 5 ft. did not change. The line looks clear of foam, but the second I start to pour, I get 50+% foam cups just about every time. I've got a feeling its because of the tap fitting
I literally had to heat up and stretch the end of the hose to fit around the fitting on top of my sankey
The tap hole is only about 1/8" wide where I have a 3/8" hose which goes to my sankey which is a 1/4" fitting (gettin 1x 3/8" hose around 2 different sized fittings is very difficult)... Here is the sankey I have with the same fitting
I believe i'm essentially pinching the beer as it goes up the line... What can I do to correct this?