akthor
Well-Known Member
So I needed a manifold for my trashcan kegerator. I didn't want to take out the one in my "Carberator" since it's attached to a dual guage secondary regulator. But I did want to be able to use 3 of the gas disconnects which attach to the manifold and regulator with MFL fittings. I wanted to be able to take them off use them for the day in the trash can then put them back on fridge duty.
So I went to the local place that carries every nut/bolt/washer/fitting known to man.
For $10 and some teflon tape I assembled my manifold. Last picture shows a MFL connected to it.
So I went to the local place that carries every nut/bolt/washer/fitting known to man.
For $10 and some teflon tape I assembled my manifold. Last picture shows a MFL connected to it.